2011 Ford Fusion Blend Door Actuator Problems

I ve been doing some research and it seems like a lot of people have this issue with this particular car.

2011 ford fusion blend door actuator problems.

Ford climate control relies on a series of ducts and a blower motor as well as a blend door assembly and blend door actuator to properly route the warm or cold air from the ac or heater into the cabin. An actuator can go bad in of two ways. Order blend door actuator for your 2011 ford fusion and pick it up in store make your purchase find a store near you and get directions. Having hvac problems on my 2010 fusion.

120 later i still have the same issue. I have replaced the blend door and sensor in dash. 2012 fusion blend door. I have a 2011 ford fusion with a little over 130 000 miles.

The fcim is the my last guess. Remove the blend door actuator and try opening and closing. Equip cars trucks suvs with 2011 ford fusion a c heater blend door actuator from autozone. Going to get a used one and see if that solves the erratic hot and cold issues.

Ac works hot pipe is hot cold pipe is cold. A problem with the blend door actuator motor in which case you must replace the actuator or a problem with a binding or stuck blend door. Temp switch cranked full cold or full hot position i get full hot blowing out vents. We have the best products at the right price.

Had no ac this morning all worked 100 last night no problems. The blower motor and blend door actuators are both mechanical devices and as with all such components prone to failure. Best advice for diagnosing and fixing a ford heater blend door actuator problem. Check here for special coupons and promotions.

Your order may be eligible for ship to home and shipping is free on all online orders of 35 00. However i found that it i put temp switch in the dead middle position. The mechanic told me that it looked like my actuator blend door was sticking so i had him order the part and replace it.